After previously trying out low-tech compression molding with a toaster oven and 3D printed molds, [future things] is back ...

Recycling plastic at home using 3D printed molds is relatively accessible these days, but if you do not wish to invest a lot of money into specialized equipment, what’s the most minimal setup that you ...

The hybrid-composite rear load floor uses unidirectional (UD) thermoplastic tapes plus direct-long-fiber thermoplastic (D-LFT) composites. Thermoplastic tapes provided high stiffness/strength in a ...

Pelliconi & C. SpA is pushing deeper into both plastic closures and the North American market through a deal to buy assets once owned by Novembal. With the deal, Ozzano dell'Emilia, Italy-based ...

Aiming to meet rising demands for carbon fiber composite unmanned aerial vehicle (UAV) propellers, Mejzlik Propellers has added compression molding capabilities coupled with a snap-cure epoxy prepreg.

Injection molded plastics have revolutionized design, innovation, and manufacturing in the 20th century. Before 1950, most products were manufactured in stamped steel, die-cast aluminum, zinc, and ...

System-in-Package (SiP) technology has been used for a wide range of electronic devices, but the warpage behavior of the package can be difficult to control and predict due to complex manufacturing ...

There are essentially three widely used technologies for manufacturing plastic products: Injection molding, extrusion, and blow molding. Injection molding is the most commonly used process for the ...